Construction
- Vision's tongue and groove extruded wallplank tube up 48" on side walls and ramp(s)
- Baked on white enamel finish on tongue and groove wallplank tubes
- Insulated nose and side panels (above tube) with white
aluminum skin inside and out
- Exterior roof corner extrusion, mill finish
- One piece sealed aluminum roof coil
- Tongue and groove extruded roof planks
- Jogless aluminum frame
- Aluminum superplank floor with I-beams on 4-1/2" centers
- Tear drop fenders
- Heavy duty wiring package and required lighting
- All lighting sealed beam and shock resistant
- Stone guard nose with 24" high deck plate
Interior Lighting
- Two interior lights (1 per stall)
- One interior light in nose area (Model 1010) or in dressing room (Model 1112 and Model 1312)
- Two recessed single pole toggle switches mounted in rear posts
Doors and Windows
- Entrance panel door (butterfly latch) curbside in nose
- 14x20 window in entrance door
- Two escape panel doors (butterfly latch), 1 roadside and 1 curbside (Model 1112)
- Escape panel door (butterfly latch) roadside (Model 1312)
- 54" side ramp curbside with panel curtain door with 1 camlock (Model 1312)
- 14x30 window with horse guard in side curtain door (Model 1312)
- 14x20 windows with horse guards in escape doors
- Tie backs on side doors
- Rear ramp with panel curtain doors with 2 camlocks
- Two 14x20 windows in curtain doors with horse guards
- 14x20 window in nose roadside
- Two 18x44 windows with horse guards, 1 in each stall
|
|
Nose Design
- Tapered arrowhead bumperpull
Running Gear
- 2-5/16 bulldog coupler
- Single sidewind jack
- Two 3500 lb axles
- Two sets electric brakes
- Five 225/75 R15 6 ply tires on silver modular rims
- Four 15" chrome derby caps
- Spare tire carrier
- Electric breakaway switch and battery pack
Exterior
- Four amber L.E.D. clearance lights
- Four red L.E.D. clearance lights
- 3 bar L.E.D. clearance light
- License plate light
- Four L.E.D. signal and tail lights
- Two fender lights
- 7 pole plastic trailer plug
- Two exterior load lights at rear
- Two tie loops (1 per horse)
- Four Vision logos
Matting
- Floor mats in horse area
- 48" matting on walls and rear ramp
- Matting on floor of dressing room (Model 1112 and Model 1312)
Stalls
- Four padded butt and chest straps
- 76" straight load horse divider with rear leg
- 2" telescopic inside removable post
- Three tie loops (1 each side and 1 on front post)
- Saddle rack mounting track in nose (Model 1010)
- Two solid mount saddle racks (Model 1010)
Dressing Room
(Model 1112 and Model 1312)
- Bridle rack with ten hooks
- Saddle rack mounting track in nose
- Two solid mount saddle seats
- Tongue and groove and panel straightwall
- Carpet on straightwall
|
